Author Topic: Domino: Serving trays splayed at 11 degrees  (Read 904 times)

0 Members and 1 Guest are viewing this topic.

Offline rzaccone

  • Posts: 2
Domino: Serving trays splayed at 11 degrees
« on: July 26, 2019, 05:27 AM »
Hello,
I want to make serving trays with sides that are splayed at 11 degrees. Since I'm gluing edge to edge I feel it necessary to reinforce the corners. Any suggestions would appreciated!

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Bob D.

  • Posts: 1254
Re: Domino: Serving trays splayed at 11 degrees
« Reply #1 on: July 26, 2019, 08:09 AM »
You mentioned dominos in the subject line, so I am guessing you want to incorporate dominos into your design. They can either be hidden as they normally are or you could make them a design element like a through mortise.

To do that you could glue up your tray frame then cut the dominos in afterward from the outside. You could set the domino flush or leave it proud like a through tenon and round off or soften the exposed end slightly. No room for oops here though since you've already glued up the tray sides. This would seem to be easier than the normal hidden domino as far as layout goes. You might need a tapered block to rest the DF500 on and get it in line with the side of the tray you would be plunging into.

I would imagine the sides of the tray are not that high so not much to bear on when using the Domino machine.

I've never tried any of this so just thinking out loud so to speak of how I might approach the same situation.

A couple tests would be in order for sure no matter what you come up with.
-----
It's a table saw, do you know where your fingers are?

Offline Birdhunter

  • Posts: 2647
  • Woodworker, Sportsman, Retired
Re: Domino: Serving trays splayed at 11 degrees
« Reply #2 on: July 26, 2019, 09:04 AM »
I built a set of serving trays similar to what you are building.

I reinforced the corners with a spline (ebony) of contrasting wood ( to walnut). I made a simple jig to hold the trays at the right angle. The jig ran against the table saw fence. I used a flat bottom cutting saw blade to cut slots on the corners. I then glued in the splines and, after drying, cut the splines flush with a flush cutting Japanese saw.

If you use a standard saw blade on the table saw to cut the slots for the splines, there will be a small gap under the spline.
Birdhunter


Offline rzaccone

  • Posts: 2
Re: Domino: Serving trays splayed at 11 degrees
« Reply #4 on: July 29, 2019, 06:10 AM »
thanks to All!