Author Topic: CMS Fence Micro Adjustment Gauge  (Read 2761 times)

0 Members and 1 Guest are viewing this topic.

Offline Woodwork Wizard

  • Posts: 431
CMS Fence Micro Adjustment Gauge
« on: May 09, 2017, 08:13 AM »
Photo 1:  0-10mm micro-adjustment gauge for CMS table saw and CMS router table.
 
Photo 2:  Aluminium 90* section goes in the slot where the module drops in and with the wood in the V-groove and tight up against the table top profile provides a very snug fit on the CMS stand. 

Can also be used to ensure the fence is precisely set parallel to the saw blade/module and can be attached on either side of the CMS, so behind the fence or in front of it as in the photo, with or without the metric dial test indicator as that is easily removed. It doesn't move the fence like a real micro-adjust - the fence still requires nudging in to position, but I don't think it would be that difficult to make something that does. I was using a Kreg Multi-Mark to measure the fence to the blade/router bit, but this thing is cheaper, far more accurate and spans a much greater distance, as well as making sure everything is parallel.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline jobsworth

  • Posts: 5997
  • Festool Baby.....
Re: CMS Fence Micro Adjustment Gauge
« Reply #1 on: May 10, 2017, 06:09 AM »
WWW,

You come up with so many clever jigs and accessories, You really should consider writing a book. I bet there would be a lot of interest in them

Offline Mark Johnson

  • Posts: 42
Re: CMS Fence Micro Adjustment Gauge
« Reply #2 on: May 10, 2017, 06:33 AM »
Very nice - inventive and clever!