Author Topic: 8020/TS 55/Rip Guides/TSO Modular Panel Saw  (Read 830 times)

0 Members and 1 Guest are viewing this topic.

Offline Richard/RMW

  • Posts: 1918
8020/TS 55/Rip Guides/TSO Modular Panel Saw
« on: October 12, 2019, 07:25 PM »
This has been on the project list for a long time. Originally I was going to make it free-standing, later I decided to find a way to fit it inside the shop footprint. After spending an hour rummaging thru the 80/20 boneyard today I found some pieces that added up to a Version 1.0 attempt. Ripping:



Crosscutting, where I'll use the 3rd set:



Basic setup:





Hardware for one set:



4 screws hold them together. Disassembled the hardware be slid along the work surface for storage:



This setup uses the 1515 sacrificial cutting thingies I already have, they get used constantly. I seldom cut on the MFT surface anymore, mostly I just plop a couple of these on the work surface and use the Rip Guides or TSO square for everything.

Full disclosure: I haven't attempted a cut yet. There is enough length to rip a full sheet of ply, I made up 3 sets of hardware and hope to try it out tomorrow.

RMW
As of 10/17 I am out of the Dog business and pursuing other distractions. Thanks for a fun ride!

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline TSO Products

  • Retailer
  • *
  • Posts: 853
    • TSO Products
Re: 8020/TS 55/Rip Guides/TSO Modular Panel Saw
« Reply #1 on: October 12, 2019, 08:56 PM »
@Richard/RMW - I see the wizard of Small is at it again - showiung everyone what is possible in the smallest of spaces - NIFTY ! !

Hans
TSOproducts.com

Home of the GRS-16 and GRS-16 PE  plus TPG Parallel Guide -  the MTR-18 Triangle - TDS-10 Dog Stop and GRC-12 Guide Rail Connector; Work Holding solutions plus AXMINSTER UJK in the USA

Offline neilc

  • Posts: 2758
Re: 8020/TS 55/Rip Guides/TSO Modular Panel Saw
« Reply #2 on: October 13, 2019, 11:15 PM »
I made your 1515 extensions years ago and use them.  This is a nice addition to that idea.

Great work and inventiveness!

Offline RightAngleDesign

  • Posts: 25
  • Your best work just got easierĀ®.
Re: 8020/TS 55/Rip Guides/TSO Modular Panel Saw
« Reply #3 on: October 14, 2019, 10:37 AM »
Thoroughly cool!
Kapex, Domino, multiple sanders, 1400, LR32, TS55