Author Topic: 80/20 Fastener for Kapex Saw Station?  (Read 577 times)

0 Members and 1 Guest are viewing this topic.

Offline Mortiser

  • Posts: 43
80/20 Fastener for Kapex Saw Station?
« on: September 11, 2019, 10:23 PM »
Has anyone used these imported right angle fasteners to fasten 4040 aluminum extrusions? If so I am curious what your experience has been with them. The price is fairly attractive. I am considering building a mitre saw station for my Kapex using 8020. Not sure if drilling and tapping would be better/stronger.
See a sample of these fasteners here...
https://www.ebay.com/itm/10-pcs-T-Slot-L-Shape-Aluminum-Interior-Corner-Connector-Joint-Angle-Bracket/143197760557?hash=item2157406c2d:m:m5MV_C9ZKqAXH-b606chenA

Thanks for your input.
Rich

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.