Author Topic: 2D or 3D model of abrasive hole patterns  (Read 1747 times)

0 Members and 1 Guest are viewing this topic.

Offline atlr

  • Posts: 108
2D or 3D model of abrasive hole patterns
« on: April 26, 2016, 10:27 AM »
Has anyone already created a 2D or 3D model of the abrasive hole pattern for various Festool sanders? 
I am creating some using Autodesk Fusion 360.  I have attached an STL file for 3D printing a D125 pattern.

Just noticed . very good work there.
« Last Edit: April 27, 2016, 11:37 AM by atlr »

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.