Author Topic: TS 55 Full Depth  (Read 440 times)

0 Members and 1 Guest are viewing this topic.

Offline Mario Turcot

  • Posts: 964
TS 55 Full Depth
« on: October 10, 2019, 05:57 PM »
I have been using the TS 55 for 1.5 year. I never cut material thicker then 3/4" (18mm). Today I had to cut ~2" (49mm). I setup the track guide and set the saw depth all the way down. I then manually engage the plunge to see if it was enough. The specs says 2" 1/8 but you never know. I realized that the blade was only going down 1"  [eek]

I couldn't find what was blocking the plunge until I notice the splinterguard was the issue.

It was not cut through and the blade was bumping on it.


If it happen to you just run the saw at full depth free air and the splinterguard will not confused you like it did to me  [embarassed]

P.S. I need to clean my blade  [wink]
Mario

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Michael Kellough

  • Posts: 4297
Re: TS 55 Full Depth
« Reply #1 on: October 10, 2019, 09:42 PM »
“P.S. I need to clean my blade‘

Good thing you didn’t try to cut something at full depth. There’d be some smoking...