Author Topic: RAS 115 problem  (Read 294 times)

0 Members and 1 Guest are viewing this topic.

Offline niyayeko

  • Posts: 1
RAS 115 problem
« on: June 10, 2022, 04:25 AM »

I've lost the spanner to remove the stickfix sanding pads. Does anyone have any other tips to remove the head? It's not releasing by hand.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline guybo

  • Posts: 386
Re: RAS 115 problem
« Reply #1 on: June 10, 2022, 07:16 AM »
Hi, thin wrenches(spanners) are available here is one set. If needed now grind down open end of wrench to fit
« Last Edit: June 10, 2022, 07:19 AM by guybo »