Author Topic: MFT 800, is the height adjustable?  (Read 661 times)

0 Members and 1 Guest are viewing this topic.

Offline pixelated

  • Posts: 226
MFT 800, is the height adjustable?
« on: February 10, 2019, 08:10 PM »
I've just purchased a second-hand MFT 800. It has two locations for the bolt that secures the top of the legs, is this intended to be a way of adjusting the table height or is there some other reason for this?

I downloaded the manual, but I didn't see any mention of using the top or bottom bolt location.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Bohdan

  • Posts: 966
Re: MFT 800, is the height adjustable?
« Reply #1 on: February 10, 2019, 08:15 PM »
The height is not adjustable. The two holes are there so that the legs will fold up under the table parrallel to each other. The two legs are different lengths to enable this to happen.