Author Topic: Is this beyond Festool?  (Read 6203 times)

0 Members and 1 Guest are viewing this topic.

Offline Michael_Swe

  • Posts: 362
Is this beyond Festool?
« on: October 02, 2007, 04:50 PM »
I stumbled on this link and was puzzled/amazed. How is this done?
Amazing bath tub

I suppose a Domino is not enough =)

//Michael

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Rob McGilp

  • Posts: 430
  • Curmudgeon
    • Damn Fine Furniture
Re: Is this beyond Festool?
« Reply #1 on: October 02, 2007, 05:23 PM »
They are really intrigueing and brilliant.
How about these?

Regards,

Rob

Offline Mike Chrest

  • Posts: 386
  • N.W. New York State
Re: Is this beyond Festool?
« Reply #2 on: October 02, 2007, 09:58 PM »
Looks like veneer laminated over a form. The outer lamination looks like slices of pie. It is layed up over a male form, more layers are put on with waterproof glue then sucked down (clamped)with a vacuum bag. It's called "cold molding".

You could do it by stack laminating solid wood (then you could use the Domino for alignment)but you would need some pretty big clamps. Or find a really big tree and have at it with a chainsaw. ;D

Mike

Cool looking bikes!
« Last Edit: October 02, 2007, 10:17 PM by Mike Chrest »

Offline Eli

  • Posts: 2503
  • A Yankee in Kangaroo Court
Re: Is this beyond Festool?
« Reply #3 on: October 03, 2007, 06:38 AM »
Made by yachtmakers..... definitely veneer over a form. I'd bet money they lay it up exactly like a boat hull. Paint with epoxy resin and polish. I like those bikes. I love the bamboo bikes too, ever seen them?
« Last Edit: October 03, 2007, 06:39 AM by Eli »
Do nothing, stay ahead.

Offline Dan Lyke

  • Posts: 321
    • Flutterby.net
Re: Is this beyond Festool?
« Reply #4 on: October 03, 2007, 11:39 AM »
eli, here's a link to Calfee's bamboo bicycles.

And rough plans for a bamboo bike trailer, although not nearly as gorgeous as the Calfee bikes. In that same realm, the bamboo bike project is about building bamboo bikes for places where incomes won't support a couple of thousand bucks for a frame.
Accomplished computer geek, novice woodworker, road cyclist, in Sonoma county, northern California.