« previous next »
Pages: [1]   Go Down

Author Topic: Interior dimensions needed in a cabinet for SYS 5 and SYS 1 using LR32 and SYsAZ  (Read 1767 times)

0 Members and 1 Guest are viewing this topic.

Offline 16paws

  • Posts: 26
  • There is no rehab for this addiction!
Interior dimensions needed in a cabinet for SYS 5 and SYS 1 using LR32 and SYsAZ
« on: October 12, 2017, 11:08 PM »
I am wondering what over interior height of a cabinet would be needed to store a SYS 1 and a SYS 5 using the SYS-AZ drawers and the 32mm system?  How much room is needed between a systainer and the next sys-az drawer?  How much room is needed on top of the upper most systainer, between its top and the top of the cabinet?

Any help would be much appreciated.

Marc
Logged
Kapex KS 120, MFT/3 Kapex, OF1400, TS75, Domino DF500, (2) MFT/3, CMS VL Set, DF 500 Tenon Assortment, Rotex RO125, CT26 HEPA, C15 and set, Drill set, the SYS-Roll, SYS-storage box, measuring tape and various sortainers.
Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline bnaboatbuilder

  • Posts: 130
Re: Interior dimensions needed in a cabinet for SYS 5 and SYS 1 using LR32 and SYsAZ
« Reply #1 on: October 12, 2017, 11:43 PM »
It's all here. This is the instruction sheet included with each sys az drawer. It's all I used and it worked out as it should.

https://service.festoolusa.com/media/pdf/706994_002_MonAnl_SYS-AZ_Auszug%20.pdf
Logged
- John
Pages: [1]   Go Up
« previous next »