Author Topic: Domino Joiner for Curved Joinery? Yes.  (Read 544 times)

0 Members and 1 Guest are viewing this topic.

Offline ChuckS

  • Posts: 4260
Domino Joiner for Curved Joinery? Yes.
« on: December 19, 2022, 03:42 PM »
Angled mortises allow you to use the Domino Joiner outside the typical casework, such as making chairs and stools with angled legs. "Curved" mortises are harder to do, but this fellow came up with a reliable technique to mill mortises for curved joinery:


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Michael Kellough

  • Posts: 5877
Re: Domino Joiner for Curved Joinery? Yes.
« Reply #1 on: December 19, 2022, 04:01 PM »
That worked, but I would have used shims (with double stick tape) to support the fence on the convex side of the curved piece.

Center marks on the backs of the rails would be transferred to the top of the curved piece then extended to the back for sighting thru the curser.
« Last Edit: December 19, 2022, 06:59 PM by Michael Kellough »

Offline luvmytoolz

  • Posts: 390
Re: Domino Joiner for Curved Joinery? Yes.
« Reply #2 on: December 19, 2022, 09:43 PM »
Good video, I always enjoy seeing how others tackle woodworking situations.