« previous next »
Pages: 1 [2]  All   Go Down

Author Topic: Domino Chair Build with Angles  (Read 4718 times)

0 Members and 1 Guest are viewing this topic.

Offline ChuckS

  • Posts: 4463
Re: Domino Chair Build with Angles
« Reply #30 on: June 20, 2022, 07:23 PM »
8mm is right as the 1/3 rule applies if you use twin tenons:





(The top tenons are parallel to the back legs.)
« Last Edit: June 21, 2022, 05:18 AM by ChuckS »
Logged
Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Tukston

  • Posts: 14
Re: Domino Chair Build with Angles
« Reply #31 on: June 25, 2022, 04:24 AM »
Great info! Your drawing with the perpendicular crossing tenons makes a lot of sense.
Thanks again:-)
Logged
Pages: 1 [2]  All   Go Up
« previous next »