« previous next »
Pages: [1]   Go Down

Author Topic: CTVA20 Cyclone compatible with the WCR-1000?  (Read 409 times)

0 Members and 1 Guest are viewing this topic.

Offline Big Al

  • Posts: 20
CTVA20 Cyclone compatible with the WCR-1000?
« on: January 08, 2021, 11:10 PM »
I just installed my new CTVA20 cyclone today. So far, so good...I've also been considering adding the work center (WCR-1000) but I'm curious if there is enough clearance to lift the clear container out of that setup to discard the shavings? Anybody have any experience with this setup?
Logged
Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline James Carriere

  • Posts: 71
Re: CTVA20 Cyclone compatible with the WCR-1000?
« Reply #1 on: January 08, 2021, 11:18 PM »
Hi Big Al,

Yes I have the CT-VA with a WCR1000 and they will work in conjunction with one another even with the clear collection bin in place.

James

Logged

Offline Big Al

  • Posts: 20
Re: CTVA20 Cyclone compatible with the WCR-1000?
« Reply #2 on: January 10, 2021, 03:20 AM »
Thanks James!
Logged
Pages: [1]   Go Up
« previous next »