Author Topic: CS70 outfeed  (Read 701 times)

0 Members and 1 Guest are viewing this topic.

Offline Big Dave

  • Posts: 2
CS70 outfeed
« on: November 05, 2022, 04:00 AM »
Does anyone know if the mw1000 extension table will fit to the back of the cs70 securely and act as an outfeed table?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline papa365

  • Posts: 2
Re: CS70 outfeed
« Reply #1 on: November 05, 2022, 01:41 PM »
It connects. They are at the same height. But not securely. Maybe ok for 1 or 2 cuts. But will drop as it only relies on the plastic connector. The bottom part doesn’t touch the cs70, unlike mft/3.


Sent from my iPhone using Tapatalk

Offline FestitaMakool

  • Posts: 1342
Re: CS70 outfeed
« Reply #2 on: November 05, 2022, 01:52 PM »
As pictured by papa365, it fits, but won’t lock as it relies on hooking onto the same profile itself is made of.
However, make a couple of home made brackets that lock the plastic connector down by utilising the one of the two t-tracks on the MW 1000 table. If these brackets are spaced to each corner it will also stabilise the MW 1000 from tilting - even on the MW 1000 itself.

I’m planning to do so, but haven’t gone doing it yet.
“The Stig” Yes, it is true, at least some part of it..
“If you have an old Land Rover and a fit wife, you’re most likely always busy”

Offline Big Dave

  • Posts: 2
Re: CS70 outfeed
« Reply #3 on: November 06, 2022, 02:59 AM »
Ok thankyou for the advice.
I’ve got to say I’m very tempted to go down this route and rig something up to make it secure.