Author Topic: accurately cutting 3" stock with a TS-75  (Read 582 times)

0 Members and 1 Guest are viewing this topic.

Offline kiarev

  • Posts: 2
accurately cutting 3" stock with a TS-75
« on: August 27, 2019, 07:28 PM »

I have a cutting table set up with a Parf Guide System and I use Festool guide rails and a TS-75 saw.  How do I accurately cut 3" laminated stock on that system??  I know I can rotate the stock around 180 degrees, but I am afraid that will severely detract from my accuracy.  Any suggestions would be appreciated.

Mark Hagy

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline jobsworth

  • Posts: 6190
  • Festool Baby.....
Re: accurately cutting 3" stock with a TS-75
« Reply #1 on: August 27, 2019, 10:43 PM »
what I did was cut the stock rotate 180 then ran it through my jointer.

Offline Svar

  • Posts: 2085
Re: accurately cutting 3" stock with a TS-75
« Reply #2 on: August 27, 2019, 11:00 PM »
Take TS75 off the rail and use the rail as straight edge instead. It might cut through.