Author Topic: Attaching router table to mft3  (Read 755 times)

0 Members and 1 Guest are viewing this topic.

Offline teocaf

  • Posts: 602
Attaching router table to mft3
« on: July 18, 2019, 10:01 PM »
I’ve only seen the 2-legged Festool router table attached to the short side (in-line, or as a continuation) of the mft3.  Is there any reason why it can’t be attached to one of the long sides?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline simonh

  • Retailer
  • *
  • Posts: 130
  • Hobbyist / Maker of the VCS-R
Re: Attaching router table to mft3
« Reply #1 on: July 19, 2019, 04:32 AM »
The Festool CMS-VL table attaches to any side of the MFT3 not just the end.