Author Topic: ATF 55E - How does the flange and counter flange come off?  (Read 1865 times)

0 Members and 1 Guest are viewing this topic.

Offline Richtes

  • Posts: 4
Have an old beaten up saw that I want to check out. Most of it seems straightforward. Does the part 36 counter flange unscrew or is it pressed on with the #37 flange?

Thanks,
Rich

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline SRSemenza

  • Global Moderator
  • *
  • Posts: 8915
  • Finger Lakes Region, NY State , USA
Re: ATF 55E - How does the flange and counter flange come off?
« Reply #1 on: July 29, 2013, 11:30 PM »
Happy first post  [smile]


I used have an ATF. If I recall the #35 screw holds the #36 flange on. The #36 flange does not screw on, just fits on and presses against the blade.

I take it is stuck in place and you want to know before prying it?

Seth

Offline Richtes

  • Posts: 4
Re: ATF 55E - How does the flange and counter flange come off?
« Reply #2 on: July 30, 2013, 08:13 AM »
Seth,
Thanks. Was eying it with a small bearing puller but wanted to be safe.

Rich