« previous next »
Pages: [1]   Go Down

Author Topic: advice on how foam installs in systainer lid  (Read 2431 times)

0 Members and 1 Guest are viewing this topic.

Offline aafoote

  • Posts: 16
advice on how foam installs in systainer lid
« on: March 24, 2010, 02:06 PM »
the foam's upside (facing systainer lid) has a raised block section and seems to have self-stick adhesive. My confusion comes from not having a surface in the systainer lid to stick it to. There is a waffled surface. The lid foam consisted in one part: the lid foam itself. Are there installation parts missing?
 maybe a piece of flat plastic and 4 miniature screws?
Logged
primary Festool source: Toolsforworkingwood.com
Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline WarnerConstCo.

  • Posts: 4162
    • Warner Mill Works
Re: advice on how foam installs in systainer lid
« Reply #1 on: March 24, 2010, 03:54 PM »
I put one of those in a systainer.

The built up part faces the front of the systainer and you just push it in.
The adhesive holds it well, it then poke the foam onto the little point things that usually hold the cardboard in the lids.

 
Logged

Offline aafoote

  • Posts: 16
Re: advice on how foam installs in systainer lid
« Reply #2 on: March 24, 2010, 04:59 PM »
thanks.  I saw the hooks. what a strange setup though! Hi-section of lid's underside sticks to hi-side of foam.
Logged
primary Festool source: Toolsforworkingwood.com
Pages: [1]   Go Up
« previous next »