Author Topic: 3 MFT joined together  (Read 300 times)

0 Members and 1 Guest are viewing this topic.

Offline RHC

  • Posts: 2
3 MFT joined together
« on: January 23, 2023, 05:09 PM »
I am setting up 3 tables to make a work bench. The center table is out of line by at least 1/16th of an inch via the dogholes. Any solutions?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Michael Kellough

  • Posts: 5877
Re: 3 MFT joined together
« Reply #1 on: January 23, 2023, 05:57 PM »
The MDF tops are held in place by screws from underneath. First I’d try removing the middle top and turning it around. If that doesn’t work loosen all the tops and try to align.

In the worst case you would have to trim a little off one side of the middle top.

Offline RHC

  • Posts: 2
Re: 3 MFT joined together
« Reply #2 on: January 23, 2023, 07:19 PM »
I appreciate the response. I may flip the whole table around and see if that helps. Was a little suprised to see it out that much. Over the whole span of 3 tables it out 1/8 inch.  [eek]