Author Topic: New Systainer³ ToolBox  (Read 1803 times)

0 Members and 1 Guest are viewing this topic.

Offline shdesign3

  • Posts: 24
New Systainer³ ToolBox
« on: December 09, 2020, 10:00 PM »
Much better handle design than current one and stackable too [thumbs up]

https://www.festool.co.uk/products/new-products/new-products/204865---sys3-tb-m-137#

Offline Crazyraceguy

  • Posts: 226
Re: New Systainer³ ToolBox
« Reply #1 on: December 11, 2020, 08:10 AM »
What is with the handle on the front? You cant carry an open topped box vertically.
« Last Edit: December 11, 2020, 08:58 AM by Crazyraceguy »
CSX
DF500 + assortment set
PS420 + Base kit
OF1010
OF1400
MFK700
TS55, FS1080, FS1400 holey, FS1900, FS3000
CT26E + Workshop cleaning set
RO90
RO125
ETS EC 125
RAS115
ETS 125 (2)

Offline cpw

  • Posts: 267
Re: New Systainer³ ToolBox
« Reply #2 on: December 11, 2020, 10:26 AM »
What is with the handle on the front? You cant carry an open topped box vertically.
I think it's all about the van racking, so you can pull it out when it is on the rails close to the systainer above it.

Offline GoingMyWay

  • Posts: 1161
Re: New Systainer³ ToolBox
« Reply #3 on: December 11, 2020, 10:52 AM »
That's exactly right.  Sedge had video on Instagram a couple of months ago explaining the front handle: https://www.instagram.com/p/CGQcupipsAn/.
Inquiring Minds Want to Know

TS55, CT26, RO150, CXS, ETS 150/3, ETS EC 150/5, MFT/3, TS75, DF500, DTS400, OF1400, CT SYS

Offline Coen

  • Posts: 809
Re: New Systainer³ ToolBox
« Reply #4 on: December 17, 2020, 11:57 AM »
The old style was stackable too, except no other stuff could be on top of the Toolbox.

This is just a "normal" Systainer with a hole cut in the lid.

Offline Agent 73

  • Posts: 20
Re: New Systainer³ ToolBox
« Reply #5 on: December 19, 2020, 01:08 AM »
I would like to know the dimensions of the opening of the L box  with the handle down.

Offline Bob D.

  • Posts: 1919
Re: New Systainer³ ToolBox
« Reply #6 on: December 19, 2020, 04:56 AM »
Looking at the photos it appears lid might be functional on the SYS3 TB. It looks like the lid could open just as any Systainer does if you rotate the latch to the correct position. Does it come with any dividers for the interior? I know it's not difficult to make them just curious if they plan to offer any. Placing your tools in that large space would be no better than a 5 gallon tool bucket, whatever you need will be at the bottom of the pile.
-----
It's a table saw, do you know where your fingers are?