Author Topic: Wallbed mechanism - which has highest weight capacity?  (Read 386 times)

0 Members and 1 Guest are viewing this topic.

Offline JonathanJung

  • Posts: 204
  • www.timberlightdesigns.com
    • Timberlight Designs
Wallbed mechanism - which has highest weight capacity?
« on: February 15, 2021, 03:17 PM »
Anyone with knowledge of wallbeds know which lift mechanisms out there have the highest weight range?

A customer is having me make a queen vertical wallbed. The designs I've come up with could be heavier than a normal cabinet faced bed panel.

Ideally it would be easily adjustable - are the coil sprung units a pain?

This one lists 240# limit:
https://www.woodworkingshop.com/product/xsmvo5411ox/


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline neilc

  • Posts: 3039
Re: Wallbed mechanism - which has highest weight capacity?
« Reply #1 on: February 15, 2021, 04:53 PM »
Rockler had some in stock.  Might check them for capacity.

Offline WastedP

  • Posts: 374
Re: Wallbed mechanism - which has highest weight capacity?
« Reply #2 on: June 12, 2021, 11:14 AM »
I have built several beds with the legit Murphy Bed hardware.  I used the Supreme Steel kits and had no problems, even with steel panels, although most were covered with applied raised panel cabinet doors.  They are fairly easy to build, install, and adjust.  The adjustment is just a matter of adding or removing a spring per side.  They also offer a heavier spring that you can use to balance it out.

People complain about the price of the hardware, but it is worth it.  If you buy direct, you're barely paying more than a dealer does.
 They offer a lifetime warranty, I've never seen one fail, and they aren't paying me to say this.

https://www.murphybeds.com/shophardware