« previous next »
Pages: 1 2 [3]  All   Go Down

Author Topic: Tips for working with aluminum  (Read 6168 times)

0 Members and 1 Guest are viewing this topic.

Offline tjbnwi

  • Posts: 6591
  • No longer in Cedar Tucky Indiana
Re: Tips for working with aluminum
« Reply #60 on: July 01, 2022, 05:36 PM »
Not aluminium but fun none the less.

Builder wanted brass spherical finials. Had the budget for me to design and turn.

The last drawings are a possible door knob project.

Tom
Logged
Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Pages: 1 2 [3]  All   Go Up
« previous next »