Author Topic: Metal Dowel connectors for Table umbrellas  (Read 3445 times)

0 Members and 1 Guest are viewing this topic.

Offline bholmsten

  • Posts: 30
Metal Dowel connectors for Table umbrellas
« on: April 26, 2014, 08:31 AM »
My Son dropped the umbrella and dented the metal connector that connects the dowels together.  I can find tons of umbrellas for sale but no replacement parts.
Does anyone have any suggestions or know where to get them etc.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Sparktrician

  • Posts: 4124
Re: Metal Dowel connectors for Table umbrellas
« Reply #1 on: April 26, 2014, 10:25 AM »
You might want to check the OD of the dowels, then go to your plumbing supplier to see if they have a connector whose ID is the same as or slightly smaller than the OD of the dowels.  You can always sand down the dowels to fit. 

- Willy -

  "Show us a man who never makes a mistake and we will show a man who never makes anything. 
  The capacity for occasional blundering is inseparable from the capacity to bring things to pass."

 - Herman Lincoln Wayland (1830-1898)

Offline Paul G

  • Posts: 1986
Re: Metal Dowel connectors for Table umbrellas
« Reply #2 on: April 26, 2014, 10:37 AM »
Not quite sure what part you're looking for but my previous search for parts for my own patio umbrella problem was futile, found nothing and would have had to have the part made and it was cheaper to just buy a new umbrella.
+1