Author Topic: Cracks in wood question  (Read 2921 times)

0 Members and 1 Guest are viewing this topic.

Offline Michael_Swe

  • Posts: 362
Cracks in wood question
« on: March 24, 2013, 03:28 PM »
Hi.
I have a quite wide oak board (about 19" wide 1 1/2" thick). I cut the end of to get in to the "crack free" segment. The cut-off broke easily at the crack in the middle. I cut off another piece and that broke as easily.

The whole board has small cracks on the surface. Does this usually mean that  the whole board will be brittle in the middle? I got the board at a good price from my neighbor. It's not assigned for any project, but I would like to know how to handle it best.

My dilemma:
- Should I continue to cut off pieces and hope for the cracks to go away? If they don't go away I'm wasting wood.
- Or should I rip the board in two and remove a couple of inches from the middle?

84394-0

84396-1

Thanks.
//Michael

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline mastercabman

  • Posts: 1854
  • NORFOLK,VA
Re: Cracks in wood question
« Reply #1 on: March 24, 2013, 03:54 PM »
Well,.... it depends on what you are planning to do with it.
Maybe best to rip it where the crack is.
I don't understand!?! I keep cutting it,and it's still too short!

Offline RL

  • Posts: 3040
Re: Cracks in wood question
« Reply #2 on: March 24, 2013, 04:50 PM »
I would rip it down the middle close to the crack. Eventually the crack will run out, and you can cross-cut at this point and join the two rips back together. It will look seamless.

You will also be able to make the most out of the cracked section of the wood left over.

Offline Michael_Swe

  • Posts: 362
Re: Cracks in wood question
« Reply #3 on: March 25, 2013, 12:35 PM »
Thanks.
I'll rip it when I know what to do with it.
//Michael

Offline jtwood

  • Posts: 233
Re: Cracks in wood question
« Reply #4 on: March 25, 2013, 11:25 PM »
How about using it as it is, in a table top, for example, and if it cracks, use thick butterfly inlays to piece it back together.  It seems to be cracking fairly cleanly.  Given the thickness of the slab, you might have to insert butterflies in both top and bottom.  This way, you can keep the full width of the unique board.

Steve