Author Topic: Bondo for ZCI -- Table saw, drill press, etc.  (Read 659 times)

0 Members and 1 Guest are viewing this topic.

Offline ChuckS

  • Posts: 3712
Bondo for ZCI -- Table saw, drill press, etc.
« on: March 02, 2022, 04:51 PM »
SawStop's ZCIs which I have three, one for the dado cutter, are pricey. I have been using a filler to give a worn ZCI a fresh life time and time again for the past few years.

Edit: I've cleared the use of the filler with SawStop before using this method to make sure the material wouldn't trigger the SawStop.
« Last Edit: March 02, 2022, 05:03 PM by ChuckS »

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.