Having trouble with your Festool power tool? Well, we're here to help you. Before posting to the forum, give us a chance to diagnose and resolve your issue. In the U.S. and Canada, call us toll-free at 888-337-8600 on Monday-Friday between 8a-5p EST or contact us via email at service@festoolusa.com. For other countries, please visit http://www.festool.com for contact information for your local Festool service department.

Author Topic: New Feature on TS 75/MFT3 Package?  (Read 1841 times)

0 Members and 1 Guest are viewing this topic.

Offline Oaklander

  • Posts: 4
New Feature on TS 75/MFT3 Package?
« on: November 27, 2013, 10:58 AM »
In the Instruction Manual for the MFT/3, page 5, Step 2, I read "using a hand screwdriver 3-3, to loosen or tighten front and back set screws" (on the saw).
Do I assume this is incorrect, and and set screws have been replaced by eccentric knobs?  The loose fit does need to be adjusted, but the knobs are almost impossible to turn.
Thanks.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Festool USA

  • Festool USA Employee
    FOG Administrator
  • *
  • Posts: 8429
    • Festool USA
Re: New Feature on TS 75/MFT3 Package?
« Reply #1 on: November 27, 2013, 11:15 AM »
I don't have the MFT/3 handy, but there are not screws for adjusting the saw to the guide rail. There are gibs/knobs as you stated. It's possible this is a translation issue.

You may want to try beveling the saw some to gain better access to the knobs, which will make it easier to adjust them. They are intended to be stiff to turn so they stay in place once set. You could carefully use channel locks pliers if needed.

And, welcome to the forum and congratulations on your new MFT/3.

Shane




Offline Oaklander

  • Posts: 4
Re: New Feature on TS 75/MFT3 Package?
« Reply #2 on: November 27, 2013, 01:04 PM »
Can't remember when I got a quicker response - Thanks, Shane.
Also, wrt the UTube videos, it appears there is a wealth of help out there for new Festool owners, so I appreciate the links.