Festool Owners Group
FESTOOL DISCUSSIONS => Ask Festool => Topic started by: JBag09 on January 11, 2016, 08:32 PM
-
I am looking into getting the MFK700 router set. I was going to order the zero degree base for it right away, but I notice there is also a edge trimming base for it. I know one is vertical and the other is horizontal, but the edge trimming base looks similar to what comes with the router in the set. What am I missing? Figured this was the easiest place to get an answer. Thanks in advance.
J
-
The set includes the 1.5 degree horizontal base. You have to buy the zero degree horizontal base separately no matter if you go basic or set.
I am looking into getting the MFK700 router set. I was going to order the zero degree base for it right away, but I notice there is also a edge trimming base for it. I know one is vertical and the other is horizontal, but the edge trimming base looks similar to what comes with the router in the set. What am I missing? Figured this was the easiest place to get an answer. Thanks in advance.
J
-
The edge trimming base has a follower bearing brake. It also has an offset plate on the base inboard side to raise the plate above the edge band. The vertical position allows you to get into inside corners/radiuses.
You can get the 700 with just the brake plate. I believe you'll find it if in the Conturo section of the Festool website.
Here you go;
http://www.edgebander.com/edge-bander-trim-router/#TrimRouter
The 700 is my favorite Festool router.
Tom
-
Thanks guys. Is there anything else I should get with the set other than the zero degree plate? Figure I may as well just get what I need at once.
-
Get the brake/edge trimming base also.
Tom
-
You will also want the 491666 router bit as well for use with the MFK in the horizontal (1.5 or 0 degree) orientation.
-
Sounds good, thanks.
-
http://www.halfinchshy.com/search/label/MFK-700
Paul Marcel has some friendly advice on the MFK-700 ^^
:)
-
I have just purchased the MFK 700 set also. My question is does parallel edge guide comes with a set or it is an option? if anybody could provide me an answer that would be great. Thanks.
James
-
James,
The parallel edge guide is an accessory that is not included with the MFK 700 Set.
-
The edge trimming base has a follower bearing brake. It also has an offset plate on the base inboard side to raise the plate above the edge band. The vertical position allows you to get into inside corners/radiuses.
You can get the 700 with just the brake plate. I believe you'll find it if in the Conturo section of the Festool website.
Here you go;
http://www.edgebander.com/edge-bander-trim-router/#TrimRouter
The 700 is my favorite Festool router.
Tom
Where do you find a part # for the bearing brake. What a great idea. I want to get it but can't find it listed as an accessory or on EKAT.
Thanks
-
If you already have the MFK 700 Set, you'll probably want the 500590 base assembly, which has the bearing brake and offset plate. Otherwise, trimming and profiling is still a two-step operation.
-
As Chris said- the 500590.
Tom
-
I realized this thread is old but wondering if the mentioned base, 500590, is the same or different than the vertical base that comes with the MFK 700 Set currently?
-
I realized this thread is old but wondering if the mentioned base, 500590, is the same or different than the vertical base that comes with the MFK 700 Set currently?
Different. It has a raised platform to clear the edgebanding. The standard one is totally flat.