Having trouble with your Festool power tool? Well, we're here to help you. Before posting to the forum, give us a chance to diagnose and resolve your issue. In the U.S. and Canada, call us toll-free at 888-337-8600 on Monday-Friday between 8a-5p EST or contact us via email at service@festoolusa.com. For other countries, please visit http://www.festool.com for contact information for your local Festool service department.

Author Topic: Conturo issue  (Read 663 times)

0 Members and 1 Guest are viewing this topic.

Offline clearcut

  • Posts: 5
Conturo issue
« on: December 02, 2021, 08:43 PM »
Hi everyone

My conturo stopped keeps shutting down.
A book with exclamation mark comes up with a number 9 beside it.

Anyone knows what that means?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline squall_line

  • Posts: 1230
Re: Conturo issue
« Reply #1 on: December 02, 2021, 08:53 PM »
I'm just quoting the manual, as I have no direct experience with it:

Problem:
Error symbol appears on the display [1-20].

Possible causes:
The machine electronics have detected a serious error.

Remedy:
Switch off the machine by pressing the on/off switch [1-8] and allow to cool for a few minutes.
Switch on the machine again by pressing the on/off switch [1-8].
If the error symbol appears again, contact after-sales service.


Did you have any other error conditions before it started doing this?  Bad adhesion, loss of contact, overheating, etc?

Online afish

  • Posts: 870
Re: Conturo issue
« Reply #2 on: December 02, 2021, 09:04 PM »
I had error 7 on mine. I had to send it in. best advise I can give you is document the issue with video. I sent mine in and they claimed they couldnt duplicate the problem which I find hard to believe since it wasnt an intermittent problem. I sent them the video showing the problem and they sent me a new one.  hae i not made a video prior to mailing it im not sure what would have happened.