Having trouble with your Festool power tool? Well, we're here to help you. Before posting to the forum, give us a chance to diagnose and resolve your issue. In the U.S. and Canada, call us toll-free at 888-337-8600 on Monday-Friday between 8a-5p EST or contact us via email at service@festoolusa.com. For other countries, please visit http://www.festool.com for contact information for your local Festool service department.

Author Topic: 110V tools used with 220V  (Read 6045 times)

0 Members and 1 Guest are viewing this topic.

Offline routerovich

  • Posts: 9
110V tools used with 220V
« on: December 05, 2010, 01:49 AM »
Hi,

I will be traveling to do work overseas where the voltage is 220V 50HZ, with my Festool US tools.
I do have an industrial 8000 step down transformer so watts are no problem, but the cycle will still be different than in the US.
From my experience with other tools and electronics this works fine, however, I would love to verify there will be no problems.

Thanks [smile]

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Ken Nagrod

  • Restricted
  • Posts: 3438
Re: 110V tools used with 220V
« Reply #1 on: December 05, 2010, 01:54 AM »
Shouldn't be a problem except possibly on the Kapex that uses a frequency control.  Best to check with someone like Lester at Festool Service on Monday.

Offline RL

  • Posts: 3040
Re: 110V tools used with 220V
« Reply #2 on: December 05, 2010, 08:06 AM »
I believe all Festools can handle a 50-60 Hz range, which will cover you in both regions.

Offline routerovich

  • Posts: 9
Re: 110V tools used with 220V
« Reply #3 on: December 07, 2010, 12:14 AM »
Thanks guys, now I feel better buying more Festools!

Offline jimmychopps

  • Posts: 1
Re: 110V tools used with 220V
« Reply #4 on: December 20, 2010, 07:44 PM »
Is there a way to configure a Festool router/joiner/saw purchased in the US to draw 220 volts? I have 220 volt power available in my shop and would prefer to use it if thats possible.

Offline sainttjames

  • Posts: 15
Re: 110V tools used with 220V
« Reply #5 on: December 20, 2010, 11:04 PM »
I had an email exchange with Dave (I think that is the correct name) - Service Guru for Festool about 6 months ago. I too was concerned about this because of a potential relocation to Europe. I was told its A-OK to use a transformer - the tools have universal motors. If you have a bandsaw on the other hand.... [unsure]